Auto Page MA-200 Bedienerhandbuch PDF herunterladen (Seite 35)

colorCONTROL C4

Step 3:

Please make sure that for the time being RAM and not EEPROM is selected for the data exchange with the

sensor (RAM is a volatile memory in the sensor, i.e. the data will be lost when power is turned off. EEPROM is a

non-volatile memory in the sensor, i.e. the data will not be lost when power is turned off.)

All the other parameters should be set as shown in the picture below. Press the tab PARA to show the

parameters. (See the FILE function in the operating instructions.)

Now press the GO button. Data exchange between sensor and PC will then start. The contents for RED, GREEN,

and BLUE that are diffusely reflected from the surface are represented as bars on the software interface. Set the

POWER value in such a way that at least one of the three bars is in the upper third of its dynamic range, but none

of them is in saturation.

ATTENTION: The sensor must be informed when you have changed the POWER value. Press the SEND button

to send this information to the sensor. Check the bars by pressing GO again. Repeat this process until you have a

suitable POWER value.

Optimally the three bars should be at approximately the same level on white paper.

If the bars vary too much, you need to perform white light balancing.

(For white light balancing see the "colorCONTROL C4“ operating instructions on the supplied CD.)

Tip! There is a trick for finding a suitable POWER value in no time at all. Set POWER MODE = DYNAMIC. The

sensor then tries to find a suitable POWER value. Check this by pressing GO. Press STOP when the bars have

"levelled out". Then press GET. The POWER value that was found now is shown in the POWER function field.

Now set POWER MODE = STATIC, and press SEND.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 55 56

Keine Kommentare

Auto Page MA-200 Bedienerhandbuch Seite 35