Auto Page MA-200 Bedienerhandbuch PDF herunterladen (Seite 38)

4. Operation of the TEMPCOMP-Scope software

If a firmware update should go wrong and the temperature characteristics that are stored in the EEPROM should

be lost, these characteristics must be created anew. For this purpose you will need a file with the corresponding

data. This file can be obtained from your supplier.

To perform temperature compensation please start the corresponding TEMPCOMP-Scope software that is

included on the supplied CD. Please make sure that you have a functioning sensor connection. It may be

necessary to select the connection with CONNECT. Set the correct sensor under SELECT SENSOR, if this is not

done automatically.

Step 1: Load the temperature compensation file that you have received from your supplier with

GET EQUATION FROM DISK.

Step 2: Press CALCULATE CURVES to display the data in the graph.

The buttons SHOW RED, SHOW GREEN, and SHOW BLUE show the individual curves.

Step 3: Select the sensor-internal operating temperature (not in °C) that the sensor has at an ambient

temperature of 20°. The value should be included in the file designation.

Step 4: Press CALCULATE CALIBRATION CURVES to calculate the mean straight line.

The buttons SHOW CF RED, … again show the individual curves.

Step 5: Pressing the SEND CF button saves the mean straight lines in the EEPROM of the sensor.

Step 6: Temperature compensation is successfully finished if the SUCCESS status message is then

displayed.

Comment!

If you do not immediately have the temperature compensation file at hand, simply start the TempComp-Scope

software. Establish a connection, if it is not already established, and simply press SEND-CF. The sensor then

functions as before, but it is not temperature-compensated.

colorCONTROL C4

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 55 56

Keine Kommentare

Auto Page MA-200 Bedienerhandbuch Seite 38